DCM – Digital Cable Monitor

DCM – Digital Cable Monitor
Monitor of Telephone Cables

dcm_frente

The equipment AT4B model allows monitoring of up to 4 telephone trunks. In the event of the cutting of a trunk, either by theft or accidental reason, the system detects and immediately reports the incident. The trunks can be divided up to three partitions, streamlining the location of the interruption. You can connect up to 4 additional sensors for monitoring the telecommunications room, and activate devices through two dry contact outputs (PGM – Programmable). Communication with the monitoring station is conducted through the Ethernet network, instantly informing the occurrence of an alarm through the DCM software.

Software DCM

Indication on the map of the cable cut in 3 seconds

Report Generator

Alarm control with notes

√ Incident Book with: equipment address, cable route on the map, indication point on the map, procedure in case of an alarm, contact telephones, and incident history.
√ Map with the locations of each alarm.
√ Indication on the map of the broken cable route.
√ Selectable map style: map or satellite.
√ Periodic updates.
√ Logs in .txt file
√ Compatible with Windows 7 or higher.

dcm_conjunto

Device Configuration with: scheduled monitoring, address and location of the equipment on a map, cable route on a map, IP number configuration, server IP, gateway, mask, and others.
Simple configuration through the interface unit, or by remote commands.
Configuration parameters protection through a password.
Connection with up to 4 additional sensors for monitoring the telecommunication room.
Up to two auxiliary activation keys. (for telecommunication room) (PGM ).
Overcurrent protection system.